...
Figure pwm.png shows the speed of the car obtained by keep the steer constant and varying the PWM. The relationship between PWM and velocity is quite linear. For some reason, when the steer input is high, the speed observed with PWM 140 is slightly lower than I would expect. On the other hand, the steer effect seems to be a little bit more complicated (see steer.png). Velocities observed for steer 92 and 120 are always very close. This may be due to the fact that curvature radius for the two steer input are very similar (the curvature radius is not linear with respect to the steer signal). Still the speed is not linear w.r.t. the curvature radius because the discrepancy between the speed for steer 36 and 64 (which I measured to have respectively a curvature radius of roughly 200cm and 100cm) tends to be reduced by decreasing the PWM.
EFFECT OF THE BATTERY AND THE POWER FILTER CAPACITOR ON THE SPEED DYNAMICS
I made an investigation on the effect that the battery has on the car speed. Data has been acquired by running car1 on a circle with constant steer and engine input. The steer has always been set to -64. The starting position of the car has always been about (3000, 3600) in global coordinates (this if you want to make considerations connected to the test-bed slope). The voltage of the battery was measured both before turning on the car (while off) and just before run ca2 (while on). The full data gathered and the detailed description of how the experiments were performed can be found in my folder on Dropbox in "../backup/data/battery_7-30-2013".
- Experiment 1: the initial voltage was kept constant while varying the pwm signal. The car is run twice in a row for 250 seconds from a starting voltage of 16.8V (turned off). See figure experiment1.png. The speed always reaches a peak and then decrease to a steady state value. The second run starts more or less from the steady state value. The PWM does not seem to affect neither the time constant nor the steady state value that is more or less always 200 mm/s below the peak.
- Experiment 2: the pwm was kept constant while varying the initial voltage. The car is run only once. See figure experiment2.png. From starting voltage 16.9V to 16.5V the speed has basically the same trend. The steady state value and the constant time becomes lower below 16.4V.
- Experiment 3: the car is run 3 times in a row to check if the third time the speed dynamics changes again. See experiment 3.png. The third time the car has the same behavior of the previous run.
- Experiment 5: the car is left turned on for 25 minutes before running to check if the capacitor gets discharged even if the car is not running. See experiment 5.png. The car 's speed is not affected.
- Experiment 6: the car is run for 200 seconds, then it is left on for other 200 seconds without running and then run for other 200 seconds. See experiment 6.png. The car 's speed has the same peak as the previous run.
The behavior dynamic of the car speed is likely caused by the capacitor that filter the power source. When the car is not running the circuit is in steady state condition. When it runs the equilibrium moves and the capacitor slowly discharges.
CAMERA MEASUREMENT ERROR CORRECTION
...