...
- Router It happened to me once that the computers kept connecting and disconnecting to the local network making impossible to estabilsh a connection between them and with the cars. When this happened, removing the internet cable from the router (the one that is plugged to the wall) fixed the problem.
- Motherboard You can test if a car's motherboard is working by connecting it to the screen and turning the car on. If it doesn't, usually the cause is the power supply unit (PSU). Try substituting that piece.
- ca2 Brainstem "Host-Stem Link: DOWN" message: try to reset baudrate console and set it back. Otherwise hardware reset. Suggestions about how to perform the hardware reset procedure (attach resistor to serial cables). Differentiate between reset brainstem (tea and reflex files are not touched) and configuring a brand new card. Sometimes the baudrate of the brainstem resets itself for no apparent reason, so first try to set back the baudrate as explained in section "Hardware Reset Procedure" in the main page of the lab wiki. If you cannot make it work, proceed with an hardware reset (described in the same section). Note that if you do not have to configure a brand new card, there is usually no need to load the tea scripts again.
- Engine When a car is particularly slow, check that h-bridge connections to the power and the motor are solid.
- Encoder gives no signal, check that the serial cable is connected in the proper way (you can find the h-bridge datasheet http://www.acroname.com/robotics/parts/S11-3A-EMF-HBRIDGE_datasheet.pdf and encoder datasheet in the electronic components catalog on the shelf).Motor doesn't run. Check that the h-bridge connections are solid. If they are, try resetting the brainstem.
- Steer is biased towards a direction. The steer cannot be set straight only mechanically. You must set the offset parameter in RoboCar_Lib.tea.
...