| Wiki Markup |
|---|
+To Run the Wavemaker: |
...
+ Use "Probe Calibration.vi" as needed |
...
Use "WaveLab_Discrete.vi" to send a wave containing discrete frequencies (for example 1 and 2 Hz). You can also set the amplitude of the second set to zero and thereby send a packet of a single frequency down the tank. |
...
Use "WaveLab_Successive.vi" to send a packet of waves at one frequency, pause, send a second packet of waves at another frequency |
...
+To Generate a Bretschneider Spectrum: |
...
+ Most likely the 2.22 Lab will be doing this. |
...
The matlab script ("BS.m" and "BS_wavemaker.m") generates the motion points. LabView on the Wavemaker Control Computer converts these points to a voltage that moves the wavemaker accordingly. |
...
Note: The formatting for LabView to read these points in is annoying and requires 1) the standard lvm header and 2) a tabbed empty column to the left of the data points. |
...
These things should be set in LabView already, so you shouldn't need to change things. |
...
I had the wave servo amp gain set at \~40 when running this motion. |
...
{attachments} |