To Dos ( 2/20/2019):

• Research interference between sensors (look at noise, accuracy), vibrations (including strength of FG) for first look at distancing
• Map sensor locations
• Look into mapping during nose cone layup (easier with two separate halves)
• Look into location of payload stack in CAD to find where the DAQ interfaces with the thermocouples relative to the base of the nose cone
• Determine wire length for thermocouples to cut, the shorter the wire the more accurate reading (less resistance), reduce mass, reduce load
  • Consider cable management system (looping wire near the DAQ, calibrate for extra resistance)
• Vibe Test
  • Test different locations 
  • Criteria: noise, accuracy
• Consider internal camera for performance for future scientific payloads