Purpose

The purpose of the mission package tube is to provide structure for the rocket and enclose other components with a smooth aerodynamic surface. It attaches 

Materials

• ID 3.9" OD 4.020"

• G12 fiberglass from wildman rocketry

Tools

• Radial indexer 
• Center Drill
• 23/64 Drill Bit
• 27/64 Drill Bit
• 39/64 Drill Bit
• 100 degree Countersink

Requirements

• Mission package tube ID must interface correctly with FRR

• Must be the correct length for the rocket to have a stable margin

• Must allow access to cameras and avionics controls

• Must withstand axial load from the piston recovery system

Manufacturing

• Set up radial indexer. Tram with dial indicator to 2 thousands of an inch accuracy in x and y, tram to 10 thousandths of an inch radially.

• Started with a stock of length 23 15/16" (this is just the size of the one from wildman, but anything that is 19.5" or longer works)

• Left 2" for clamping space on one side 
• Center drill --> through hole --> counter sink
  • Drill holes at 1200 RPM & counter sink at 200 RPM 
• Move to the next set of holes based on drawing.
• Flip the tube after the first half set of holes to finish the rest. 
• Cut the tube to size, leaving 0.01" extra which would be sanded down to exact size

Testing

The mission package tube will be tested by fit checking it with other components to ensure correct alignment and fit, and may be sanded or have holes adjusted if necessary.