The position of the car on the test-bed computed by the CPS is affected by a considerable error. I made some manual measurement of this error by finding the real position with the measuring tape and checking the computed position on the CPS and I found it to be be up to 30cm. Moreover, when the tracking of a car pass from a camera to another, the global coordinates "leap" because the position error in the transition point is different for the two cameras.
I made some investigation on the trend of this error. The results are shown in error_trend.png. In the figure, "x_loc" indicate the x coordinate in pixels in the local coordinate system of the camera (i.e. the horizontal one), while "x_glob" is the x coordinate in cm in the global coordinate system. Remember that the axises of the local and the global coordinate systems are inverted. Data where gathered for two cameras.
I decided to consider the error linear along both direction and try to apply a correction to the computed global coordinates. The correction is thus applied in the form err = a*x_loc*y_loc + b*x_loc + c*y_loc + d. The parameters a, b, c, d are computed by the CPS on start by loading a file where the real global coordinates of four points must be saved. This is the procedure that must be followed to configure this file. This procedure must be repeated for each camera. It is calibration-independent, meaning that you do not have to repeat it if you have to perform a new instrinsic/extrinsic calibration, but if the camera is moved, the procedure must be done again.
# Set the variable RECORD_OBJECT_DATA = 1 in the file CPS.h in the computer responsible for the camera that you want to configure and compile it. For information about compiling the CPS, check the original lab documentation.
# Run CPS.exe. The RECORD_OBJECT_DATA mode was designed to take pictures of the cars symbols so it will ask you the car number and the section number, just put a negative number. The only thing you must insert correctly is the camera number that you want to configure.
