Unless stated otherwise, connector positions are described as looking at the outside of the box.
source: http://www.reprise.com/host/circuits/transistor_pinouts.asp
main power plugs put positive on the right, ground on the left |
Arduino Shield <-> Power Board
|
Modifications and Bodges:
|
Self Power Reseton kestrel this has been modified as follows to prevent the positive input from hitting the positive rail. |
3.3V power for radio box |
External Connectors on cpu boxnew radio boxes now use 3.3volts on the control pin |
FTID USB-COM232-PLUS42 - rxd modem port A freewave port B external/altimeter port C |
Additional Information:
|
RJ45 reference:In 100BaseT link only orange and green pairs are used, blue and brown are spare. External ConnectorSee cpu section above Wiznet (WIZ108R)Make sure serial debug mode is turned off in configuration tool
Freewave:RS485 pinouts: RS232 pinouts: COM1 used for RS485 COM2 used for RS232 Moxa rs232/rs485 converter (TCC-80)db9 rs232 side uses rs485 side must have ground connected moxa dip switches: 1 and 2 on (rs485 two wire), 3 off (no termination) Bullet PoEPOE on spares uses Overall:
|
Positive power bottom left, ground bottom right