- Chee Wee discussed experiments with dipole
- verify that the dipole oscillator is working with large piezo-electric sensor
- signal output becomes erratic at lower frequencies (below 40 Hz)
- results similar to those from loud speaker experiments
- Remi discussed simulations of beams in fluid flow
- future work will include investigating a beam with varying bending stiffness along its length
- Pablo discussed plans for experimental wake detection
- plan is to start experiments around the end of May
- 3 hour meeting planned in Singapore
- 11am on June 2
- Heather discussed forced vibration experiments
- troubleshooting force data
- continued forced vibration experiments in May here in Boston
- plans to do PIV experiments in Singapore in June
- Stephen discussed the manufacturing of the round 5 sensor
- design of process flow complete
- sensor will be ready beginning of June
- Jeff discussed pressure sensors for the kayak
- desired sensor (amplified honeywell sensor) has been selected
- looking for a distributor in Singapore
- these need to be purchased in Singapore
- Vicente suggested investigating a pressure sensor block Scanivalve, which has been used in wind tunnel turbulence experiments
- up to 80 tubes connect to block to measure pressure
- Vicente
- wrapping up thesis writing
- James discussed changes to the rotating cylinder experiment apparatus
- flexure couplings for shaft alignment
- tensioning pulley
Overview
Content Tools
Activity