...
- Wet sand mold to 2000 grit using sanding block (made of foam)
- MAKE SURE TO PROTECT EDGES with some flat piece of aluminum or other rigid material, or you'll get a lip on the seam in the end that you need to sand
- Wax mold (3 layers of Mold Release Wax, yellow container). For each layer of wax,
- Get a dab of wax on a shop towel and start applying to the mold (top and inside and on either end for good measure)
- Rub in circles until you can't see streaks anymore and there is no more resistance (this is called "buffing")
- Let set for 15 minutes in between coats
- Apply PVA film with fine-haired brush, let set for 20 minutes
- Mix cabosil + epoxy and apply to mold (thick on edges)
...