...
- Adjustable wrench
- Mutlimeter
- Small Screwdriver
...
Materials:
- x1 Bottom Polycarbonate (PC) Layer
- x1 Middle PC Layer
- x1 Top PC Layer
- x1 DAQ PC Mount
- x1 Right Angle 3-pos bracket
- x6 4-40 screws
- x6 4-40 nuts
- x4 1/4-20 threaded rods
- x8 1/4-20, 7/8" L steel coupling nuts (90268A029, McMaster)
- x8 1/4-20 steel nuts
- x1 6-32 screw switch (MissileWorks)
- 6-32 screws
- 4-40 M-F standoffs
- x1 Pyxida antenna w/ cable, lock washer, nuts
- x1 Telemetrum antenna w/ cable, lock washer, nuts
- 1x 3D printed Battery holder
- 1x Thermal DAQ
- 4x M-F/F-F M3 standoffs
Procedures:
- Prepare the following sub- assemblies vefore before dressing:
- battery holder square
- middle square with DAQ mounted
- solder power on screw switch
- Run power wires through the top square to bottom square
- Mount battery holder square first, pick up power wires
- Connect power to battery, mount middle square
- Run antenna cable through the middle square
- Mount antennae (2) to the top square
- Mount top square
- Mount screw switch
- Add nuts on top plate
- Get batteries
- Prepare nose cone TCs in tip (if not already made)
- Silde on nose cone and bolt in place
...