Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Choose Data Access -> Select single experiment from either of the two Madrigal sites listed above.

  2. Leave "Use all Madrigal sites" selected so you search over all Madrigal sites.
  3. For "Instrument category" choose choose "Fabry-Perots".
  4. Select the "Arecibo Imaging Doppler Fabry-Perot".
  5. Select year 2018, month January, and day 15.
  6. Note that from this point on, the options are similar to the List experiment user interface.  
  7. This time we will print the file with and without filters.  Select the one file listed, then choose "Print file" and "As is".
  8. Next we will print the file, but filter by data quality.  To learn about data quality, choose "Show plots" and "Description of data quality (FPI_DATAQUAL) parameter".
  9. Next choose "Print file" and "Select parameters/filters".
  10. Open the "Select Parameters to include" section by clicking on it.
  11. Click or hover on any of the parameters to see its definition.
  12. You could select any parameters to print, including derived ones in grey.  For now select just the parameters in the file by clicking "Select all parms in original file" at the top.
  13. Close  "Select Parameters to include" section by clicking on it, and open "Select filters to use (optional)".
  14. In the bottom section select or type "FPI_DATAQUAL" as the filter parameter.  Leave the lower limit blank, and set the upper limit to 0.  This will remove all data with values above 0.
  15. Verify the resultant output only has values of 0 for FPI_DATAQUAL.

...