...
Screw diaphragm into Cup with four grub screws using a 7/64 hex wrench
Integrate the T-fitting into the piston's inlet port (top side) with 2x plugs and 2x FireBolts, a pair on each side. Make sure the T bar is horizontal with respect to the end plate.
Insert detailed BP procedure here
Screw the Payload bulkhead into the top of the piston using 4x 1/4-28 bolts that are 3/8ths inches long. You need a 3/16ths hex key.
Insert Avionics Bay
Insert detailed AV Bay procedure here
Put the coupler over the piston and screw in the lower bulkhead. The switchband should be nearest to the Payload bulkhead.
The milled face should be internal to the Avionics Bay.
Put a nut on one side of the piston rod and screw the piston fully into the diaphragm.
Put a nut on the other side of the diaphragm and counter torque the nuts.
Adjust the piston height so that the piston-cup assembly with bulkheads reach a total of 28 inches tall. It should actually be slightly less, but this is adjusted by trial and error later on in integration.
Put the mission package tube on over the assembly. “Struggle with clocking” - Jakob, 11:20am
Screw in four ½” 8-32 screws.
Screw in the nosecone with the right clocking using four 8-32 screws.
Put the mission package assembly on the fin can and secure with 3x 6-32 shear pins. For the Pathfinder vehicle, you will need to skip every other hole.
...