You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 2
Next »
| Test | Kerf Input | Voltage | Speed | Offset | Notes | Pictures |
|---|
| 0 | ? | ? changed in middle of cut to 20 V | .03 in/s | .25 | - glue fell apart
- kerf was too big
- dimensions were off
| N/A |
| 1 | .06 in | ? either 20 V or ~18 V | .04 in/s | .25 | - glue fell apart
- wire was not cleaned in between cuts
| N/A |
| 2 | .06 in | ~18 V | .04 in/s | .25 | - glue fell apart (it appeared that the surfaces that were glued together were not flat, but had dents)
- wire cut right down seam
- it looked odd (it's the one on the right in the picture)
|  |
| 3 | .06 in | ~18 V | .06 in/s | .15 | - glue fell apart (it appeared that the surfaces that were glued together were not flat, but had dents)
- new offset avoided seam
- cut was clean
|
Unknown User (itorres@mit.edu)
Changes to investigate:
- use styrofoam?
- cutting many cross-sections and stacking them
- cutting quarters instead of halves to avoid glue issue
- measure correct kerf