...
Triangle of exposed area near the fins --> adjust size of cutouts
Below is a table showing the mass of each cutout size. One of each size was measured, so this is technically not an "average" mass, but we expect that since the laser cutter was used to make the cutouts, the mass of each size is more or less the same.
| Layer Size | Dry mass of one layer |
|---|---|
| 1 (smallest cutout size) | 20g |
| 2 | 22g |
| 3 | 23g |
| 4 | 26g |
| 5 | 33g |
| 6 (largest) | 39g |
| Total mass of all cutouts (6 sizes x 4) | 652g |
Vacuum Bagging
Vacuum bag was 32 x 38" (this is TOO BIG, make smaller next time. For the test fin can though the bagging was too SMALL, so find a good middle ground)
...