Versions Compared

Old Version 14

changes.mady.by.user Claire Buffington

Saved on

compared with

New Version 15

changes.mady.by.user Claire Buffington

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Attach integrated piston to payload bulkhead with ¼-28 bolts- the clocking matters! clocking mark to be added

  2. Attach the integrated AV tower to payload bulkhead with 6-32 bolts. The elbow/ tee fitting assembly must be turned slightly inward in order to fit the AV Tower on top

  3. Wire piston to AV tower

  4. Attach recovery guard to piston using ¼-28 bolts and washers **orientation matters will update

  5. Screw on God Nut

  6. Attach payload stack to payload bulkhead

  7. Attach nosecone coupler using 3 chamfered 6-32 bolts, attach nosecone

  8. Integrate soft goods and tender descenders **Will update with line diagram 

    1. Another QL at end of MP Riser to Motor Section Riser (wide Black) and Main Riser (Blue Spectra)

    2. Main Bag Bridles and load-bearing riser to QL to a 1500 black Drogue Swivel to drogue riser

    3. Drogue riser to QL to drogue lines

    4. Connect bottom of drogue bag to Motor Riser inside swivel

    5. Connect Motor Riser to loop to swivel to loop to eyebolt

    6. For tender descenders from Main Bag TD loops to eyebolt:

      1. Wear goggles and gloves to measure appropriate black powder using weigh boats, scale, and popsicle sticks

      2. Hold TD loops in place, pushing towards center to ensure the loops don't get caught. Check that the loops slide freely.

      3. Use funnel to fill TD with black powder

      4. Push the two pieces of TD together

      5. Repeat with second one

      6. Connect TDs to Main bag 


  9. Tighten all quick links with a wrench

  10. Screw antirotation rod into diaphragm with locknut

  11. Attach diaphragm. Screw on skinny god nut and place diaphragm on. Next screw the eye nut on and insert cotterpin. Finally, hold the god nut with small pliers and screw the eye nut tight. Fold down and gaff tape over the spikey bits of the cotterpin!

  12. Set up integration stands. Stand piston-diaphragm assembly and cup close to each other.Thread main bag with lines and tender descenders through cup, so tender descenders are close to the diaphragm. Pull tender descender wires through half-moon shaped hole and attach tender descenders to eye nut.

  13. Push cup (with main bag, TDs and lines) onto diaphragm and secure with 10-32 grub screws

  14. Attach swivel (on motor riser) to quick link on top of main bag

  15. Quick link drogue to drogue riser