Page History

Test Breakdown

Test Article: Test NC, from layup #1

Benchmark	Test Config.	Criteria for Success
I. DAQ must be continuously operational under [TBD] F, [TBD] C	NC is mounted on a test jig to isolate it from the floor of the oven DAQ is mounted on a test jig to isolate it from the floor of the oven	Records accurate temperatures (within expected 5 degree error, or allowable by reason) in SD Card and NAN Flash Memory for 7 8 min
II. Determine approximate thermal boundary conditions between inner wall and outer surface of NC at one selected node point	NC is mounted on a test jig to isolate it from the floor of the oven DAQ is mounted on a test jig to isolate it from the floor of the oven NC is plugged on both ends with insulation	Records accurate temperatures for the node point (within expected 5 degree error, or allowable by reason) in SD Card and NAN Flash Memory for 7 min

...

III. Epoxy joints must survive continuous heating up to 8 minutes

Same as above

Sensor leads must feel secure when tugged after continuous heating.

3/13/2019 (Diane, Miske, Juan):

...