Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
  1. Materials: need DP-420 NS Epoxy for fillets and System 4000/4600 Hardener
  2. Fin Manufacturing
    1. Waterjet G-10 Cores
    2. 5 Carbon fiber layups and sanding
    3. Leading edge 
      1. emphasis on symmetry 
      2. Sanding board at angle is constrained by the 2 x 4s, fin is slowly slid in with different holders for each leading edge. 
      3. need to calculate geometry for a defined inner angle
        1. NOTE: Created test fins, found that average thickness of carbon fiber layer was 0.009 inches.
    4. Alignment Jigs
    5. Jig for fiberglass layups
  3.  Camera Shells

...