Test Breakdown
Date to be conducted: 3/16/2019
Test Article: Test NC, from layup #1
Benchmark | Test Config. | Environmental Parameters | Criteria for Success |
---|---|---|---|
I. DAQ must be continuously operational under [TBD] F, [TBD] C |
| Records accurate temperatures (within expected 5 degree error, or allowable by reason) in SD Card and NAN Flash Memory for 8 min | |
II. Determine approximate thermal boundary conditions between inner wall and outer surface of NC at one selected node point |
| Records accurate temperatures for the node point (within expected 5 degree error, or allowable by reason) in SD Card and NAN Flash Memory for 7 min | |
III. Epoxy joints must survive continuous heating up to 8 minutes | Same as above | Sensor leads must feel secure when tugged after continuous heating. |
Results
Test 1:
Time Conducted: 2:30 PM
Setup:
(Insert photo here)
Battery Voltage: 3.93 V
Time Stopped: 2:40 PM
Conclusion:
Notes
3/13/2019 (Diane, Miske, Juan):
- Brought test NC w/ 6 thermocouples installed from lab to oven room in basement of 37
- Discussed and outlined Oven Test above
- "Wool" insulation, nose cone mold for support, foam cut outs for support, test for thermal coefficient, test for daq nominal operation
3/16/2019 (Diane, Miske, Juan):
- Got masonry blocks to support NC in oven
- Using normal PVC insulation wire for power, route through thermocouple inlet
- Mount daq on a masonry block